2017 SGS M8 Screamin Eagle Power Vision LED
#22
#25
#26
Since I have some CVO bits and pieces, I have the CVO windshield trim and badges that will be going to powder coating.
#27
11. Rear Wheel - Finally, weather is improving and winter mods are done. To match the front wheel, I powder coated the stock 16" Enforcer rear wheel. I wanted to make sure that the "linked brakes" feature and ABS worked, so I used HD ABS bearing. I compared an aftermarket wheel bearing and the HD ABS bearing had a larger surface area for the sensor (green part). No ABS errors!
Aftermarket ABS bearing surface area (green part). This might throw ABS error codes.
Aftermarket ABS bearing surface area (green part). This might throw ABS error codes.
Last edited by sgt_gman2005; 04-14-2018 at 05:35 PM.
#28
12. Blacked out parts - Since I was committed in blacking out my bike, I started sending my parts to D-Tech Coatings for gloss black powder coat. By doing in increments, it made the wallet's workload easier. D-Tech's gloss black is the closest to OEM as far as color. It's hard to explain but I noticed that the color is shinier and more depth compared to my local powder coater. D-Tech's exchange program of chrome to black parts was also fast, it prevented down-time since parts arrived immediately.
I also swapped the SE Street Cannons with black and sold the chromes. This forum's market place section have a lot of goodies to buy and sell.
I am still contemplating on the bars so I left it untouched. I might go with Twin Peaks gloss black soon.
I also swapped the SE Street Cannons with black and sold the chromes. This forum's market place section have a lot of goodies to buy and sell.
I am still contemplating on the bars so I left it untouched. I might go with Twin Peaks gloss black soon.
Last edited by sgt_gman2005; 04-14-2018 at 05:29 PM.
The following users liked this post:
Alexspain (04-15-2018)
#29