no one of the brake switches is on

 

Turn signals should only be be when you activate them when turning right or left; they are not used as running lights.

 

John/Panz - Thanks for clarifying. Back to it tonight. Getting close to finishing this thing (at least this round)..
Nick

 

Need a little more help with this. I don't have the front signals wired in yet. With a test light on either the brown or violet wire in the rear harness plug, pressing either the L/R turn signal button will only faintly light the light.

If I put on the emergency signal switch, I get a a light. Neither are flashing. Do the flashers themselves need to be grounded? How do I test them?

 

dim is a ground issue

 

I'm not great with wiring. The thing I'm missing is how the flasher connects to the turn signal wiring. The green wires go to the flasher and an orange wire runs from the other pole of the flasher to the terminal board. Circuits 1 and 2 is where the violet and brown turn signals connect to the terminal board.

How do they connect to each other?

 

I'm not great with wiring. The thing I'm missing is how the flasher connects to the turn signal wiring. The green wires go to the flasher and an orange wire runs from the other pole of the flasher to the terminal board. Circuits 1 and 2 is where the violet and brown turn signals connect to the terminal board.

How do they connect to each other?

 

OK, so I looked at the diagram again and see that the emergency flasher provides the connectivity. Still need to determine troubleshooting steps.

 

the orange is your hot 12 volts to directional's via the flasher and on to the buttons and the brake lights as well uses the orangs hot

the green and violet is left and right blinking power to the left and right bulbs front and rear when the button is pushed

 

Thanks John. I have 12v on orange side of the flasher relay. Nothing happens on the green wire pole when I press either turn signal button on the controls.

Emergency switch in the 'on' position has 12 volts at violet pole and I have 12 volts on turn signal pins at rear harness.

Relay?