Show me your FLST/F non stock handlebars!
#14
See my posting on this thread:
https://www.hdforums.com/forum/softa...andlebars.html
..... and here's a few pics of my Narrow Beach Bars. Hope this helps.... JR
https://www.hdforums.com/forum/softa...andlebars.html
..... and here's a few pics of my Narrow Beach Bars. Hope this helps.... JR
Last edited by JR Ryder; 04-20-2009 at 02:32 PM.
#16
#17
Handlebars for a Fatboy
Well, I´ve braided cables with the stck bars. I´m not thinking in ape or large beach bars because the change is to much expensive. The mentele bars of customrides look good (I don´t know if in this model I can put the electrical cables inside), and the Narrow Beach Bars of JR Riders are cool (are there Harleys?), the Fatboy bars of coop57 are cool too, but wich is the brand?
By other side I think that 504's look very similar to the stock FatBoy bars, I think that my fatboy must look a little low in the bars and a couple of inch low in the rear (cool look coop57)
In my opinion, the 1 1/4 bars with elecrical inside is the best but I want to use the stock switch houses and the same raiser. Advices are welcome.
lopezlago: Motorcycles on Canvas
By other side I think that 504's look very similar to the stock FatBoy bars, I think that my fatboy must look a little low in the bars and a couple of inch low in the rear (cool look coop57)
In my opinion, the 1 1/4 bars with elecrical inside is the best but I want to use the stock switch houses and the same raiser. Advices are welcome.
lopezlago: Motorcycles on Canvas
Last edited by lopezlago; 04-14-2009 at 09:24 AM.
#18
Hey lopezlago, yes my bars are Harley brand. Have a good look at this thread. LOTS of good info on here. I'm not sure if you are going to attempt the work yourself. You can use the stock risers if you have a newer model and they are 1-1/4", BUT you MAY need to relocate the signal lights as they MIGHT hit the gas-tank. (stock risers are lower that the HD ones recommended for my NBB's).
https://www.hdforums.com/forum/softa...ecth-help.html
https://www.hdforums.com/forum/softa...ecth-help.html
Last edited by JR Ryder; 04-14-2009 at 11:36 AM.
#19
good point, I´ve not thinking in the fatboy's turn signal location . the mine is a 95 model, the bars diameters is 1", I will need a bars with this diameter in the raiser position.
#20