2008 nightster build
#15
sorry it took me so long to get back to everyone with questions...was in Alabama helping with the clean up after the Tornado and storms. i am from north bama where the storms hit family and friends homes...
i did a 2in tank lift so that i could tuck all the wires and connectors under the tank. i then removed some of the wire loom and used an L bracket to run the harness for the ignition switch. there is a ground on the back side of the trans where you can mount it.
i will try to get some pics of the mounting of the ECM. it was very simple i just removed the plastic when i chopped the fender and then zip-tied it to the frame.
the shocks are stockers but i cleaned them very well and then scuffed them with a scotch pad. cleaned them again and then painted them with flat black paint.
i did a 2in tank lift so that i could tuck all the wires and connectors under the tank. i then removed some of the wire loom and used an L bracket to run the harness for the ignition switch. there is a ground on the back side of the trans where you can mount it.
i will try to get some pics of the mounting of the ECM. it was very simple i just removed the plastic when i chopped the fender and then zip-tied it to the frame.
the shocks are stockers but i cleaned them very well and then scuffed them with a scotch pad. cleaned them again and then painted them with flat black paint.
Last edited by ROB9550; 05-02-2011 at 10:24 AM. Reason: update
#16
you dont have to move anything but i thought that it would look better with out the speedo sticking up higher than the bars. its really easy to do but i cant remember the part number for the bracket that i used.
Thread
Thread Starter
Forum
Replies
Last Post
DocHoliday06
Sportster Models
79
02-26-2015 11:23 AM