Crappy license plate holder?
#1
Crappy license plate holder?
Ok so I went to install my plate on my new to me bike....this thing is a piece of garbage....it two of the tiniest screws holding the bottom of the plate bracket.....if you don't tighten it enough, of course it won't hold the plate.....and if I tighten it more, the top of the plate juts out and the bracket comes off....what's up with this thing.....I'm guessing this is why a lot of people change out their license plate holder......
Is this a common problem...bike in question is a 12 road king.....I don't wanna spend a lot on a new holder but any cheap fixes would be appreciated....I tried searching but everything was about changing the holder to a lay down plate etc....ryan
Is this a common problem...bike in question is a 12 road king.....I don't wanna spend a lot on a new holder but any cheap fixes would be appreciated....I tried searching but everything was about changing the holder to a lay down plate etc....ryan
#2
#3
#4
Pull it off and see what hardware you can swap to make it better...
that was added by the previous owner, the road king cop version has the plate mounted on the radio box carrier ( it's like a tour pak mount).
so you are dealing with whatever was done to it by the previous owner.
Mike
that was added by the previous owner, the road king cop version has the plate mounted on the radio box carrier ( it's like a tour pak mount).
so you are dealing with whatever was done to it by the previous owner.
Mike
Last edited by mkguitar; 01-23-2015 at 10:27 AM.
#6
#7
Trending Topics
#8
#9
Thread
Thread Starter
Forum
Replies
Last Post