So, hate to rehash an old thread, but I have all the parts and figured why not do it. I'm pretty dumb when it comes to electronics, so how do I know which one of the posts to solder to? Attached picture shows the back of the board. The switch I need to wire into is TP 57, 58, 55, 32 going clockwise. Trial and error, or does someone know which two posts I need to solder to?
Soldered it all up and the remote and switch I used works great, but it looked like **** on the bike. Ordered some new blanks for the switch blanks and a harley odo reset switch. I'll redo it again later in the week when the parts come in. I got the switch from radio shack, small, but just didn't look right. I called it the successful failure lol. I'm debating now about mounting it on the left side behind the pop off body cover. It would just be a small hole with the switch coming out....not very noticeable, easy to get to if I need to replace the battery, and easy to hit with my left hand rolling into the driveway.
Nicely done. I've been wanting to come up with a clean look and not have to worry about losing or having my opener stolen. Thanks for sharing and taking the time to post step by step instructions WITH pix.