Here's mine with the frenched trim ring. You have to loosen the screw on the original ring a little bit so the new rings lip can fit behind it. No gap if done right.
Do a search for "lovebug slaughter". That is my bike with the rings installed. The stock ring stays in place and you SNAP the french ring on top of it, easy peasy. If you need, put needle nose vice grips on it to close the gap so you can get the nut and bolt started, it will work and close the gap. Good luck to ya, Happy Holidays everyone!
HD Part numbers:
7" headlight bezel - 69733-05 $43.95 list
Passing Lamp bezels - 69732-05 (pair) $59.95 list
Turn Signal bezels - 69749-05 (pair) $46.95 list
You can order them for Kutter HD at about 20% off list with free shipping (orders over $100). But I bought them at my local dealer at 15% off for their Black Friday sale. They were within $25 of Kutter for the set with tax and for $25 I prefer to keep my dollars local.
I put that ring on my bike and just hated the butt crack. Took it back to the dealer and told the parts guy to never sell me crap like that again. Just sayin.
I didn't have any trouble closing the gap. It looks just like the stock ring gap on the bottom. Maybe they've changed it? I dunno, but I'm happy with mine.
I put that ring on my bike and just hated the butt crack. Took it back to the dealer and told the parts guy to never sell me crap like that again. Just sayin.
It goes on easy peasy, you wasn't doing it correct, just sayin!