Harley Davidson Forums
Here is a pic from the floor looking up at the rear TT unit installed. 2nd TT bracket attaches to rear motor mount with supplied longer bolts. Use adj nut in center of link to adjust 'tension' - not too tight/loose - then tighten lock nuts.
Here is a pic from the floor looking up at the rear TT unit installed. 2nd TT bracket attaches to rear motor mount with supplied longer bolts. Use adj nut in center of link to adjust 'tension' - not too tight/loose - then tighten lock nuts.
0 2013/06/04 10:32:34
Front TT install much easier than rear. Jacked up bike, and used a 2nd jack on motor to relieve tension on motor mount bolts. Remove two nuts at top, mount TT bracket, then tighten/torque lock nuts.
Front TT install much easier than rear. Jacked up bike, and used a 2nd jack on motor to relieve tension on motor mount bolts. Remove two nuts at top, mount TT bracket, then tighten/torque lock nuts.
0 2013/06/04 10:32:34
After mounting front TT bracket, set gap at 'stop' nut at 3/8."
After mounting front TT bracket, set gap at 'stop' nut at 3/8."
0 2013/06/04 10:31:31
Remove two front motor mount bolts and install front TT bracket with supplied longer bolts from TT. Now would also be a good time to check condition of front motor mount and frame gap, if any. Be sure to torque new bolts to proper value. Connect stabilizer link, adj tension, tighten lock nuts. Double check everything, then take for a ride.
Remove two front motor mount bolts and install front TT bracket with supplied longer bolts from TT. Now would also be a good time to check condition of front motor mount and frame gap, if any. Be sure to torque new bolts to proper value. Connect stabilizer link, adj tension, tighten lock nuts. Double check everything, then take for a ride.
0 2013/06/04 10:31:31
Remove two hold-down bolts and flip dash over on its side - be sure to use rag/cloth to protect tank.
Remove two hold-down bolts and flip dash over on its side - be sure to use rag/cloth to protect tank.
0 2013/06/04 10:09:11
Gently spread two ears on ECM/Speedo connector and slide off.
Gently spread two ears on ECM/Speedo connector and slide off.
0 2013/06/04 10:09:11
Mounting bracket for Speedo is held on in three places - gently pry fingers off.
Mounting bracket for Speedo is held on in three places - gently pry fingers off.
0 2013/06/04 10:08:30
Remove bracket, then pull Speedo out of dash from other side.
Remove bracket, then pull Speedo out of dash from other side.
0 2013/06/04 10:08:30
Here's a side-by-side of the old and new.
Here's a side-by-side of the old and new.
0 2013/06/04 10:08:30
The backside of the old and new - the new is a direct 'plug-n-play replacement.
The backside of the old and new - the new is a direct 'plug-n-play replacement.
0 2013/06/04 10:07:26
Connect supplied ECM Data Port connector.
Connect supplied ECM Data Port connector.
0 2013/06/04 10:07:26
Locate Data Port connector on fuse panel. Slide connector to the left to remove from panel, then pull off rubber boot to expose connector.
Locate Data Port connector on fuse panel. Slide connector to the left to remove from panel, then pull off rubber boot to expose connector.
0 2013/06/04 10:07:26
Connect new Speedo/Tach via connector cable, turn on bike IGN and RUN switches (motor does not need to be running) and ECM will transfer mileage/data to new Speedo/Tach.
Connect new Speedo/Tach via connector cable, turn on bike IGN and RUN switches (motor does not need to be running) and ECM will transfer mileage/data to new Speedo/Tach.
0 2013/06/04 10:06:20
In only a few seconds 'OK' will show on the display and the new Speedo/Tach is 'married' to the bike.
In only a few seconds 'OK' will show on the display and the new Speedo/Tach is 'married' to the bike.
0 2013/06/04 10:06:20
Install new Speedo/Tach by reversing previous steps, turn on ACC switch to set up new Speedo/Tach.
Install new Speedo/Tach by reversing previous steps, turn on ACC switch to set up new Speedo/Tach.
1 2013/06/04 10:06:20
 
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
© 2026 MH Sub I, LLC dba Internet Brands