hello fellow mcy enthusiasts

i want to secure a soundstream 4.25 amp to the top of scotts ezzell's bracket. I saw one guy welded angle iron to the bracket to screw down the amp. I don't have the ability to weld.

will using industrial strength velcro to the top of the bracket be enough to safely secure the amp? Will heat break down the adhesive on the velcro?

any and all suggests would be helpful

thnx
joe
2010 ultra

 

Industrial strength Velcro will hold. I had the same setup you're looking at and had it installed with Velcro. It will hold.

 

Velcro is perfectly fine. It's not going anywhere inside that fairing.

 

Another plus for the Velcro. That amp will be so snug as it is it isn't going anywhere.

 

thanx guys

 

Velcro here also.

 

Does the industrial strength velco come with the AMP kit, or can it be found at home depot? I know dumb question, but I honestly dont know. sorry.

 

home depot sir.

http://www.homedepot.com/p/Velcro-In...0593/202261931

 

Both of mine are velcro secured.....

 

Actually I bought mine at Walmart, strips are 2" wide l, I used 2 of them about 6" inches long each.