Rear turn signal help
#1
Rear turn signal help
I had to get dual filament housings on the rear of my 2008 Street Bob, they came in today and they are 3 wire. My stock ones were 2 wire and I can't figure out how to wire them up so that I can still use my RUN/TURN/BRAKE module.
I have the LED inserts and hooked up the ground and the one that was the brightest (turn signal) but when I hit the brake nothing happened but the turn signal blinked normal then fast light there was a light out. I'm not electrical smart so I have no idea what to do...HELP!!!!
I have the LED inserts and hooked up the ground and the one that was the brightest (turn signal) but when I hit the brake nothing happened but the turn signal blinked normal then fast light there was a light out. I'm not electrical smart so I have no idea what to do...HELP!!!!
#3
#5
#6
#7
Trending Topics
#9
Join Date: Feb 2007
Location: Harmelen (The Netherlands, Europe)
Posts: 8,986
Received 867 Likes
on
576 Posts
Rear turn signals are single filament.
You cannot use the dual filament housings in combination with the R/T/B module.
Go here to find 2008 Dyna models wiring diagrams.
If you want to use the dual filament housings you have to connect the blue wire to pin 1 on the tail light board and the 5W filament will light up like the day marker on the front.
Pin 1 = tail light
Pin 2 = brake light
Pin 3 = ground
Amp Socket Wiring Housing 3-Position p/n 73153-96BK
Receptacle Contact p/n 73191-96
You cannot use the dual filament housings in combination with the R/T/B module.
Go here to find 2008 Dyna models wiring diagrams.
If you want to use the dual filament housings you have to connect the blue wire to pin 1 on the tail light board and the 5W filament will light up like the day marker on the front.
Pin 1 = tail light
Pin 2 = brake light
Pin 3 = ground
Amp Socket Wiring Housing 3-Position p/n 73153-96BK
Receptacle Contact p/n 73191-96
#10
Thread
Thread Starter
Forum
Replies
Last Post