simple top end rebuild
#32
Seems like it's my day to thank everyone,going down the list.The top end came out very good after the advice I got here.Heads were a mess,three leaking valve seal and a burnt exhaust valve.Made a rough set of torque plates out of 1"plate,used all thread and pulled them to 60lbs torque,no distortion.New rings,new valve (found a used one)reseated them with all new seals and good to go.Thanks everyone this was a good project for a good man in a bad spot.The party afterwards was great as he had no idea we were doing this.Cant really thank you guy's enough.
#33
Seems like it's my day to thank everyone,going down the list.The top end came out very good after the advice I got here.Heads were a mess,three leaking valve seal and a burnt exhaust valve.Made a rough set of torque plates out of 1"plate,used all thread and pulled them to 60lbs torque,no distortion.New rings,new valve (found a used one)reseated them with all new seals and good to go.Thanks everyone this was a good project for a good man in a bad spot.The party afterwards was great as he had no idea we were doing this.Cant really thank you guy's enough.
#34
Exactly. 1 Qt. every 2000 miles is not excessive. I'd run it until it used about twice that amount. You can buy a lot of oil for the cost of even a budget tear down...
Thread
Thread Starter
Forum
Replies
Last Post
babalu
General Harley Davidson Chat
14
04-16-2013 07:32 AM