That's them alright and good to know the RH side can be put somewhere else than where mine is - the spot yours is in looks much easier to reach so I think I will move it there while I have access.
Originally Posted by ROCKOUT Rocker Products
I was doing a speaker install on my '15 Limited Low today. I've been in that fairing doing audio stuff at least a half dozen times, probably had to push those connectors out of the way & didn't realize what they were. Thanks to the posts above, now I do. On mine, they are right out in the open. The throttle side is right behind the volt meter...
The clutch side just hangs down next to the fork tube. It's right next to an almost identical plug I think goes to the front fender...
'Least I'm pretty sure that's them lol.
Thanks again to all for pointing me in the right direction
I plan on ordering these Small Heated Hand Grips - 56196-08A(http://www.boardtrackerharleyonline....rips-56196-08a) and from understanding I need an additional electrical connector kit 69200722. Can these be installed without taking the bars off? Has anyone installed these exact same grips? I am wondering how much larger they are from the OEM Ultra Limited Low grips (they are smaller in diameter then the regular Ultra). I like the smaller diameter of the OEM grips and I figured these will be larger then the OEM just not sure how much larger.
I'm interested in those same grips. Anxious to see how your install goes.
__________________
NO, they DON'T all do that!
ROCKOUT rocker shaft inserts... make the tapping STOP! From the guy that FOUND and CURED the problem NO ONE ELSE COULD, thank you for your support! Ordering & info http://www.rockout.bizOn ebay! ...CLICK HERE Also on amazon.com...
I just received notice from Surdyke that the left heated Airflow grip, part # 56100097A, same as OEM on the CVO limited is on "extended backorder". Hope it doesn't take much longer since I've already started the handlebar swap out on my CVO Street Glide. I'm at a stopping point until the left side grip arrives!
I was doing a speaker install on my '15 Limited Low today. I've been in that fairing doing audio stuff at least a half dozen times, probably had to push those connectors out of the way & didn't realize what they were. Thanks to the posts above, now I do. On mine, they are right out in the open. The throttle side is right behind the volt meter...
The clutch side just hangs down next to the fork tube. It's right next to an almost identical plug I think goes to the front fender...
'Least I'm pretty sure that's them lol.
Thanks again to all for pointing me in the right direction
You may want to use a meter to check the plug above the radio. That looks like a power supply that is put there for accessories. I (per Harley instruction sheet)used that to power the antenna relocation. (antenna kit was a waste of money by the way....... it is laying in my toolbox).
You guys who have done this, did you splice in a wiring extension for the right side heated grip connection or did you re-route the wires above the radio in order to reach?
11-01-2015, 12:49 AM
