Specific wiring question?
Thread Starter
|
Road Warrior
Joined: Aug 2014
Posts: 1,915
Likes: 392
From: NJ
Specific wiring question?
now that I have RCA outputs off the back of my radio. I can easily install an amp going direct from my radio to the amp with RCA’s. How do I tie the speaker output of the amp to the speakers? Is there a connector I need to buy so that I unplugged the speaker before the pods and can just plug right into there? Or should I just pop a little hole in the back or bottom of the pod and run fresh speaker wires right to the speaker? I guess I could also just cut the wires in the jumper Wiring to interrupt the signal out to the speakers, cap them off, coming out of the radio, and use the amp wiring to the output side. I tend not to like to cut up the actual bike wiring, but if it’s an Easily replaceable jumper that I don’t care about hacking it up
Last edited by Jersey Drew; Today at 10:56 AM.
Thread Starter
|
Road Warrior
Joined: Aug 2014
Posts: 1,915
Likes: 392
From: NJ
figured it out. can rcd from radio to amp and then from amp to speaker pods with the Cicada HDXFLXFO. now with that do i just wrap the plugs that i leave with electrical tape or do i need to find some sort of plug to stick in the end?
Last edited by Jersey Drew; Today at 01:05 PM.
Road Captain
Joined: Jul 2015
Posts: 725
Likes: 70
From: Billings, Montana Out in the Wild West.
Last edited by madsonp; Today at 01:21 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Shark.Glide
Audio Systems
24
Apr 14, 2026 07:46 PM
HARLEY100TH
Audio Systems
19
Sep 1, 2019 10:33 PM
