07' Street Bob IAC issues, breather mod??
#1
07' Street Bob IAC issues, breather mod??
I have an 07' Street Bob w/ 14k miles and I seem to be having intermittent issues with the Idle Air Control. After longer cruising the bike tends to die when coming to a stop. I have run some Techron through the gas and cleaned the IAC a few times and it's helped but I wanted to get some thoughts on doing the crankcase breather mod so the oil isn't spraying back into the heads helping to clog up my IAC anymore. Do you think the breather mod will help with that issue?
#4
#6
There is no upside to venting the hot, oxygen depleted, oily crankcase gas back in to your A/C; it makes a mess of your throttle body and A/C coating it in a black oily residue.
Venting to atmosphere; happy intake, happy engine, happy rider... but an unhappy EPA Too bad, so sad...
Venting to atmosphere; happy intake, happy engine, happy rider... but an unhappy EPA Too bad, so sad...
#7
There is no upside to venting the hot, oxygen depleted, oily crankcase gas back in to your A/C; it makes a mess of your throttle body and A/C coating it in a black oily residue.
Venting to atmosphere; happy intake, happy engine, happy rider... but an unhappy EPA Too bad, so sad...
Venting to atmosphere; happy intake, happy engine, happy rider... but an unhappy EPA Too bad, so sad...
Trending Topics
#8
I've changed up my external breathers quite a few times, this is by far my favorite. With external breathers if you use a filter you will need to occasionally wash it as it will slowly become oil saturated. Never any mess with this, and my throttle body and A/C are clean.
This is the kit I used: http://www.dkcustomproducts.com/Twin...-ACI-TC-BR.htm
I picked up a spare breather filter so one is always clean and ready to go. Since I took that image I added 5/16" fuel injection clamps to the 3/8" hoses to make sure it never has an unintended removal
This is the kit I used: http://www.dkcustomproducts.com/Twin...-ACI-TC-BR.htm
I picked up a spare breather filter so one is always clean and ready to go. Since I took that image I added 5/16" fuel injection clamps to the 3/8" hoses to make sure it never has an unintended removal
Thread
Thread Starter
Forum
Replies
Last Post