did turn signal relocation//first time had a washer in the wrong place but turn signal funtioned properly//took it apart to put the washer in the correct spot//now turn signals blink too fast on that side//anyone know why they would blink too fast

 

Not enough electrical load on the relay.&nbsp\\; Make sure you have a good ground connection.

 

No other changes?&nbsp\\; You're not running LEDs are you?&nbsp\\; They will cause that and give a 1121/1122 code.

 

Check the other bulbs make sure they are blinking.

 

usually a bad&nbsp\\;ground or bulb.

 

+1

 

If you did the relocation, did you cut the wires and them in-line butt-connect them. If you did be sure that the crimps are tight an the wires are touching the metal in the connetions.

 

Blinker fluid is too thin. When relocating the blinkers, straight 50 weight fluid is needed.[\\\\\\]