Sissy bar installation
#1
#3
You dont have to relocate them but you have to install a different mount for them.
You need this for the front mount 53961-06
and to replace the mounts for the turn signals you need 53968-06B (I think the number has been changed to 53968-06C but the website still shows the B)
You need this for the front mount 53961-06
and to replace the mounts for the turn signals you need 53968-06B (I think the number has been changed to 53968-06C but the website still shows the B)
Last edited by bberck; 08-08-2009 at 10:12 PM.
#4
#6
#7
It can be a pain getting the wires pushed through but its not a hard job.
Trending Topics
#9
I am wondering the same thing as the 180 mm Wide Tire Kit #43768-06 has a note that says if a Dyna Saddlebag Kit has been previously installed then you can discard the rear fender brackets etc. and only use the tire in the kit. Seems like a waste to buy the kit, should have just purchased the tire #43197-04A. Anyway, this note is very vague as I have a detachable sissy bar and saddle bags that are useing the #53968-06 docking hardware. The 53968-06 fender bracket is tight to the fender but not as tight as the included fender brackets. I am not able to use the included fender brackets as the rear bolt location isn't threaded so I may need to modify the existing fender brackets. Has anyone installed the wide tire kit and left the 53968-06 fender brackets as is?
#10