Andrews 54H cam results
#13
#14
Join Date: Jul 2007
Location: sand mountain Alabama
Posts: 4,749
Likes: 0
Received 15 Likes
on
14 Posts
Andrews 54H cam is not really a high lift cam so to say. The lift is only .555 but to some cam's it is.
According to Andrews they recommend 10.1 compression.
I have looked at many dyno sheets using this cam and of course there are a lot of configurations. The bottom line is you can gain a lot from some head work. Every dyno sheet I looked at with at or over 100hp/100tq. had head work. There were a couple that got close to the 100/100 without head work but most was below it.
From the dyno sheets it looks like a very good Torque cam.
According to Andrews they recommend 10.1 compression.
I have looked at many dyno sheets using this cam and of course there are a lot of configurations. The bottom line is you can gain a lot from some head work. Every dyno sheet I looked at with at or over 100hp/100tq. had head work. There were a couple that got close to the 100/100 without head work but most was below it.
From the dyno sheets it looks like a very good Torque cam.
Thread
Thread Starter
Forum
Replies
Last Post