Jeez they sure are proud of that retaining ring. .good find though will keep the kit in mind.

 

To add to my response.. you can use any gaskets that work and are designed for the 2006 Dyna. Just make sure you replace the Inner Primary Bearing with a Baker Sealed bearing because since you removed the inner primary.. it has a MUCH better chance of going back on misaligned because of the 2 missing inner primary alignment dowels that the 2006 Dyna's don't have. When I took mine off everything was perfect so its possible that my IPB may have lasted for a very long time BUT... because I removed my inner primary housing it has a very good chance of going back on with a slight bit of misalignment. The Baker High Torque bearing part # 189-56 will take care of that. Its only $40.00

 

Take the bike to a friggin SHOP! If you have no clue what an oil seal is then you should not be working on the bike yourself.

Do you even have a HD Service Manual?

 

Yes, it's an old thread, but I didn't see the part number for the black inner primary to case gasket.
34948-08 gasket, primary housing to case, Black

 

so why answer a 5 year old question to a guy that isn't on here anymore?

 

I just figured that someone else might also be interested in using a black primary housing gasket and I would save them some time trying to research this. I found very few hits while investigating this.
Did I do something that is generally considered unusual or strange by the hdforums population in general?

 

I was happy to read about it.

I'm assuming the visible edge is black...unlike the raw metal of the recent one I bought?

 

Yes.