Need help
Hello ladies and gents,
I have a 97 Roadking. Was riding the other day and my speedo stopped working as well as the light for my gas gauge? Left turn signal indicator on my dash stopped working too as well as turn signal cancellation on both sides? Was on the hwy doing 160km/h for a few kilometres and then it happened. I'm thinking a short from the high speed vibration? Any thoughts would be much appreciated.
Thanks in advance,
Edster 69
I have a 97 Roadking. Was riding the other day and my speedo stopped working as well as the light for my gas gauge? Left turn signal indicator on my dash stopped working too as well as turn signal cancellation on both sides? Was on the hwy doing 160km/h for a few kilometres and then it happened. I'm thinking a short from the high speed vibration? Any thoughts would be much appreciated.
Thanks in advance,
Edster 69
More likely it's a bad/corroded connection. Try pulling apart the connections and checking for corrosion. Sometimes just the act of pulling them apart and putting them back together will clean them enough for things to start working again.
I am also having electrical problems with my 1992 FLSTC. I am in the process of replacing and upgrading the rear wires and lights. It has been suggested to me and i am strongly considering replacing the main wiring harness. I have some visible corrosion on connectors.
I am far from an expert. I am just learning. I would look at whatever I could get easy access to.
On my bike there are connectors under the seat that are easy to get to. I would look at those and all the bulb sockets I could easily get to.
My bike has other connectors under the gas tank. They are harder to get to.
My understanding is that tracking down electrical problems can be difficult. Several people have strongly suggested that I replace the main wiring harness. I am strongly considering it, but I understand it is a tedious chore.
On my bike there are connectors under the seat that are easy to get to. I would look at those and all the bulb sockets I could easily get to.
My bike has other connectors under the gas tank. They are harder to get to.
My understanding is that tracking down electrical problems can be difficult. Several people have strongly suggested that I replace the main wiring harness. I am strongly considering it, but I understand it is a tedious chore.
Originally Posted by Edster 69
Hello ladies and gents,
I have a 97 Roadking. Was riding the other day and my speedo stopped working as well as the light for my gas gauge? Left turn signal indicator on my dash stopped working too as well as turn signal cancellation on both sides? Was on the hwy doing 160km/h for a few kilometres and then it happened. I'm thinking a short from the high speed vibration? Any thoughts would be much appreciated.
Thanks in advance,
Edster 69
I have a 97 Roadking. Was riding the other day and my speedo stopped working as well as the light for my gas gauge? Left turn signal indicator on my dash stopped working too as well as turn signal cancellation on both sides? Was on the hwy doing 160km/h for a few kilometres and then it happened. I'm thinking a short from the high speed vibration? Any thoughts would be much appreciated.
Thanks in advance,
Edster 69
Good luck.
Under the dash would be a good place to start.
I had a problem with my 1997 Softail not starting. Traced it to a bad connection under the dash panel between the tank.
I had a problem with my 1997 Softail not starting. Traced it to a bad connection under the dash panel between the tank.
Trending Topics
Ya, flip that dash over and pull the seat up, you have a ground corroded or loose in one of the connector bodies, a single ground wire can possess all the things you have acting up. Check your ground on the battery while you have the seat up also
Thread
Thread Starter
Forum
Replies
Last Post







