PC V post-install performance
#1
PC V post-install performance
so I installed SE air cleaner, V&H BSS, and PC V + auto-tune over the weekend.
The bike runs spectacular, so I know the PC V piece is working well.
Couple things I have noticed, and I'm wondering if anyone else has seen this,
is that when I start the bike it usually takes 3 or 4 chugs before it starts.
Once it starts there no hesitation or roughness at all, just that it takes noticeably longer to fire up.
Before the install it started more or less instantly. One chug of the starter and it was running.
the other thing I noticed is that when it sits at idle, the idle kinda wanders up and down slightly rather than sitting at a steady pace. Very slight, but noticeable.
Do these sound more or less normal?
Thx!
The bike runs spectacular, so I know the PC V piece is working well.
Couple things I have noticed, and I'm wondering if anyone else has seen this,
is that when I start the bike it usually takes 3 or 4 chugs before it starts.
Once it starts there no hesitation or roughness at all, just that it takes noticeably longer to fire up.
Before the install it started more or less instantly. One chug of the starter and it was running.
the other thing I noticed is that when it sits at idle, the idle kinda wanders up and down slightly rather than sitting at a steady pace. Very slight, but noticeable.
Do these sound more or less normal?
Thx!
#2
If you want it to start right away you can start it before the the engine light goes out. this topic has been discussed ad nauseam in the forums.
#3
This is an 09 and a PC V.
Doesnt matter to me if it takes longer. Just wondered if this was normal.
Last edited by chunks; 07-06-2009 at 10:17 AM.
Thread
Thread Starter
Forum
Replies
Last Post