Removing Wire Connectors and Soldering Wires Together
#1
Removing Wire Connectors and Soldering Wires Together
Hi everyone,
I just internally wired my new set of bars and I want to clear some space under my tank. I was planning on cutting the connectors that attach the switch control wires and just soldering the wires together. I can solder fairly well so I am not concerned about this aspect, I just wanted to make sure that removing connectors and soldering the wires would not mess any electrical components up. If anything, it seems like a good solder would last a lot longer than exposed wire into a plastic connector.
If anyone has any thoughts or experience, please let me know.
Thanks!
I just internally wired my new set of bars and I want to clear some space under my tank. I was planning on cutting the connectors that attach the switch control wires and just soldering the wires together. I can solder fairly well so I am not concerned about this aspect, I just wanted to make sure that removing connectors and soldering the wires would not mess any electrical components up. If anything, it seems like a good solder would last a lot longer than exposed wire into a plastic connector.
If anyone has any thoughts or experience, please let me know.
Thanks!
#4
Thread
Thread Starter
Forum
Replies
Last Post
georgiabiker
General Harley Davidson Chat
11
03-19-2008 06:57 PM