Drive Belt Problem on Frankenstein Trike. - Harley Davidson Forums

Hacked, Conversions and Trailering "Harley Sidecar, Conversion Trikes and Motorcycle Pull Behind Trailering Enthusiasts" A forum for the discussion of your sidecar, Conversion Trike or Pull Behind Motorcycle Trailer.

Drive Belt Problem on Frankenstein Trike.

  #1  
Old 09-16-2018, 12:09 PM
Shari Davis Coleman
Shari Davis Coleman is offline
New Member
Thread Starter
Join Date: Sep 2018
Location: TX
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Unhappy Drive Belt Problem on Frankenstein Trike.

New to the group . Just replaced the belt on my 2008 XLR Sporster Frankenstein Trike. Having issues with front drive belt walking off . Any one else ever had this issue?
 
  #2  
Old 09-16-2018, 04:08 PM
TinCupChalice's Avatar
TinCupChalice
TinCupChalice is offline
Extreme HDF Member
Join Date: Feb 2015
Location: Galt's Gulch - MI
Posts: 10,887
Thanked 8,612 Times in 3,926 Posts
Default

Welcome to the forum!

I'm on a Frankenstein Dyna Wide Glide, but my first thought is the rear axle alignment. To set belt tension the bike has to be on the ground to properly set the belt tension and rear axle alignment.

To adjust the alignment and belt tension you work from the drive line side; the right side on a Sporty in your case, with the four rear mounting bolts loose. The drive line side adjuster nut is first tightened to factory belt deflection spec; tighten the jam nut on the adjuster, then on the opposite side walk the adjuster up to the spacer so it's in contact with the spacer, then tighten the jam nut. From there you torque the four rear mounting bolts to 60 ft-lbs.

The simplest way to explain it, is to hold your arm out; small movements at your shoulder are much more exaggerated at your fingertips; if your rear axle is out of alignment that will position the drive belt at a different position on the transmission pulley.

In the case of my Wide Glide I know the belt tracks slightly inboard on the transmission pulley, once I did the conversion; the rear pulley still tracks true, to the left side. My first thought in your case is your rear axle alignment is out of spec allowing the belt to walk off the transmission pulley. Did you do the conversion yourself, or have a dealer/indy do the job? The rules in the service manual go out the window once you trike your ride Please do keep us updated!

http://frankensteintrikes.com/images...de_2004-up.pdf

 
  #3  
Old 09-17-2018, 11:33 AM
Dieselnerd's Avatar
Dieselnerd
Dieselnerd is offline
New Member
Join Date: Aug 2011
Location: MN
Posts: 69
Thanked 19 Times in 13 Posts
Default

Ditto to what Tin Cup said. My Frankenstein trike is a Sportster. I did not use a new belt when I did the conversion because mine only had 2200 miles on it.

It's very easy to get the rear axle slightly cocked when adjusting the belt tension and that can cause the belt to walk off the front pulley. You MUST have the full weight of the trike on the ground when checking the tension.

After I had the tension perfect I held a long straight edge (5 foot tubing) on the center of each rear wheel (needed help from the wife to hold a straight edge on one side) and discovered the axle was slightly cocked when the straight edges were compared to the front wheel which was held in perfect center by concrete blocks.

The left side needed to be tapped forward just a tiny bit and tightened down. After that I raised the rear off the ground by raising the bike and the rear the same amount. I spun the axle in both directions and the belt stayed where it belonged. Rechecked the tension and it was still OK. After a test ride it still remained where it belonged.

Sounds like a lot of monkey business but like Tin Cup said, you have to figure out a lot of this stuff yourself.
 
The Following User Says Thank You to Dieselnerd For This Useful Post:
TinCupChalice (09-17-2018)


Thread Tools
Search this Thread
Featured Sponsors
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2018 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
 
  • Ask a Question
    Get answers from community experts
Question Title:
Description:
Your question will be posted in: