Clutch case/hub assembly
#1
04-12-2019, 12:07 PM
Join Date: Dec 2017
Location: TACOMA
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Clutch case/hub assembly
New heavy duty Barnet Scorpian kit installed. After bolting primary chain case cover, I noticed clearance between clutch cover and inside face of chain case cover has maybe 3/16 inch clearance. JP Cycle tech support said should not be a proble. Has anyone reading this post had any issues similiar after heavy duty clutch installation?
Thread
Thread Starter
Forum
Replies
Last Post