Andrews 48h Cams & Vance and Hines FP3
#11
#12
#13
Well, I can guarantee you that my bike would cut off at a stop, hesitate and stall when taking off, sputter all the way through shifting to 3rd.... Got them to send me another tune, had the same issue. Their response was that I needed to run 3 20 minute autotune sessions to fine tune it. Did that, still had most of the same issues. All is good now though as I ran into a few guys on here that had the same setup(aside from choice of mufflers) that I was running and they were kind enough to share their tunes with me. I loaded them and ran 3 20 minute sessions and the bike runs like a champ!
The following users liked this post:
smurf211 (08-25-2023)
#14
Well, I can guarantee you that my bike would cut off at a stop, hesitate and stall when taking off, sputter all the way through shifting to 3rd.... Got them to send me another tune, had the same issue. Their response was that I needed to run 3 20 minute autotune sessions to fine tune it. Did that, still had most of the same issues. All is good now though as I ran into a few guys on here that had the same setup(aside from choice of mufflers) that I was running and they were kind enough to share their tunes with me. I loaded them and ran 3 20 minute sessions and the bike runs like a champ!
#15
Need advise please.
Lol..... if I would have done my full research(forums included) before I purchased the FP3, I would have bought the Power Vision as well. I had them send me a tune for my bike with the Andrew's 48's in it.... and its what's running like crap on the bike. I am going to double check everything with the cam install today and then give them a call... but I know the Power Vision is a more robust tuner capable of more than the FP3. Couple that with purchasing it from Fuel Moto and receiving lifetime tune support from them and their files, I think I will be happier in the end with the way the bike runs/performs.
#17
Thread
Thread Starter
Forum
Replies
Last Post