I finally got all my parts for the Secondary Amplifier and Installation Kit (Rockford Fosgate Stage II) to install in my 21 Street Glide CVO and I can't for the life of me find connector 350A. of the primary amplifier harness. Directions say to route 350A into the battery box area and I just can't locate it. The only connector I can find in the immediate area is behind the left side cover, just below the Battery charger connector. Is it one of these connector in the schematic?

 

No One???

 

Wow, not even a Rockford Fosgate comment? Tough crowd.

 

Do you have a Harley Factory Service Manual? Where does the manual say the connector is located?

 

#7 is 350A with a cap off the primary harness

 

No, I don't have the manual, yet> I have seen the other drawings above and they didn't help either. What has happened is, if you buy the Rockford Fosgate stage II system over the counter @ Harley, The Primary Amplifier comes included with the Bluetooth Dongle (Which is where my problem is). If you buy a $60,000.00 2021 Street Glide CVO Or Roadglide CVO and its the exact Rockford Fosgate Stage II system, Harley has in their dubious wisdom neglected to include The dongle in the system, so now you are forced to buy the $205.00 dongle and harness. The connection for my secondary amplifier is in the bluetooth dongle harness, go figure. Anyway, I ordered the dongle and harness. The harness is suppose to arrive on Thusday 5/12 and the dongle, who knows, the dealer said its on backorder and they didn't know when. I'll keep ya posted. I can't wait to hear them tour-pak speakers bark.

 

FYI I ordered the harness and dongle last week. The dongle harness is shipping this week the dongle is backordered until 9/15/2022. I called all over the country to find at a dealer. Found 2 first dealer asked to ship but would not because of Harley new policy. 2nd dealer I was able to talk him into shipping to my dealer. Picked up yesterday.

 

I can't beleive something could be backordered that long ( 9/15/2022.). I'm getting the harness tomorrow and I'm hoping I can get some sound out of my tour-pak with out the dongle (for now). I think the speakers will work but I just don't have the ability to fine tune without the bluetooth dongle, I'm hoping>

 

Got my dongle (finally) and am going to install today. Below is the instructions of the wiring for the sec.amp and I guess there is no 350A plug you connect on this model, you don't use that connection on the CVO model.
I'll keep ya posted.
Leo

 

Good luck on getting your secondary amp and speakers working. Interesting that HD uses a different set up for a CVO. I thought the 360A plug from the primary amp would be under the right side cover and the secondary amp would be plug/play.

I’ll watch for updates.