Rear Speakers Output from Stock HD Radio
Thread Starter
|
Road Master
Joined: Apr 2008
Posts: 935
Likes: 1
From: Indiana
The rear speaker outputs from the radio will not be active if the HK amp is in the circuit. The CAN Data Bus will shut down the rear output.
Without the HK amp in the circuit, the rear speaker outputs are always active. If the fader is not flashe on, the front, rear outputs default to a 50 / 50 split (it does not default to full forward)
The dealer flash will only activate the fader
With the HK amp in the system, the fader will default to the amp.
Hope this helps
Without the HK amp in the circuit, the rear speaker outputs are always active. If the fader is not flashe on, the front, rear outputs default to a 50 / 50 split (it does not default to full forward)
The dealer flash will only activate the fader
With the HK amp in the system, the fader will default to the amp.
Hope this helps
Extreme HDF Member
Joined: Apr 2006
Posts: 10,449
Likes: 46
From: Roswell, GA
It's only been in the last 2-3 years or so that HD has used ONLY the front HK outputs to the CVO amp. For example, in '06 and '07 HD sent BOTH the front and rear signals from the HK to the amp.
Good luck with your project.
Carl
Good luck with your project.
Carl
Thread Starter
|
Road Master
Joined: Apr 2008
Posts: 935
Likes: 1
From: Indiana
Thank you, Carl.
Former Sponsor
Joined: Apr 2009
Posts: 618
Likes: 9
Thank you IronCrossAudio. That clear everything up for me. One question: if I connect the CVO amp outputs (with CAN bus + and -) to front and rear, and flash the radio, will the fader work? Reason I ask is if I remember correctly, the CVO amp only take signal from the radio's front speaker wires, and not both front and rear.
Yes, the fader will work, but only at the amp. The head unit will still default to front outputs only.
Thread Starter
|
Road Master
Joined: Apr 2008
Posts: 935
Likes: 1
From: Indiana
Great, thank you for the info. I can proceed with the project.
2nd Gear
Joined: Dec 2013
Posts: 6
Likes: 0
From: Texas
Adding CB to 2014 TriGlide
Mine came with the PTT button and CB antena. If I do a self install the instruction say....
Since the speakers already function why do I need to pay the dealer to do the flash?
A speaker software flash must be performed on the radio
installed on the motorcycle at the dealer before the speakers
will functioninstalled on the motorcycle at the dealer before the speakers
Since the speakers already function why do I need to pay the dealer to do the flash?
Stellar HDF Member
Joined: Jul 2009
Posts: 2,825
Likes: 2,140
From: Hope Mills NC, bye CA!!
You asked a good question but you asked it on the third page of an old thread about something different. People will read from page one and reply to the old question. You may get an answer here but start a new thread if you dont.
Stellar HDF Member
Joined: Sep 2013
Posts: 3,487
Likes: 606
From: USA
A FLHX (Street Glide) would not have rear speakers unless maybe a CVO.
Here is the 2011 wiring diagram ... maybe it will help.
Thread
Thread Starter
Forum
Replies
Last Post
