Hi,

I am just about to change the stock bars to Burly 12" narrow glide apes on my 2004 xl1200c, I have been told that there is a large connector block hidden in the stock pull back risers that I am also changing to 2" straight, just wondering, if any one on the forum has done this, and if so where have you relocated the connector?

any advise appreciated.

 

I pulled the wires tight in the harness on mine and ran it around the right side of the neck. Mine is black so it kinda disappears. It would have been nice if there was enough slack to get it under the tank!

 

No large connectors on the 04-06 models. If you look in my album I have pictures of that area showing what is there and what is involved.

 

My 2005 1200C before and after. 16" burley narrowglides with 1200L speedo mount