These are used V&H Dresser Duals in good condition for $220 + shipping. When I added cams I had the the 18mm bungs installed by Tilly's HD in Salisbury ($100 value, unless you can weld).

One of the pictures show where I leaned her over to far and rode the header. It can't be seen when installed unless you get down on the ground.

Here is a link with details on the header:
https://products.vanceandhines.com/store/harley/16752/

 

Price drop $200! + shipping.

The crossover pipe was replaced with the new style mounting bracket and flange.

These make your bike sound more old school.

 

Can you use a lift with these pipes. It seems like the pipe is below the frame. I use the red lift from Sears and the pads rest on the frame.

 

Yes you can! The frame is about 1 to 3/4 inches below the header. I do most of my own maintenance and use a similar lift all the time.

 

You have a Pm

 

Sent you a PM!

 

I have an '08 RKC so this wont fit my yr..

 

Yep... 2009 and up Harley changed the frame so the cross over tube goes between the trans and rear tire.

 

Will my SE slip ons work with these, i assume it is just the header pipes. Do these have the cats in the header pipes? Also do you have plugs for the bungs you had installed.

Thanks

 

Yes, they will work with your SEs. There are No cats in them. And the plugs are installed in the 18mm bungs... Here is a video with them installed on my bike with the Eliminator 400...