Harley Davidson Forums
0 2019/08/03 14:03:44
0 2019/07/24 03:52:46
0 2019/07/24 03:51:58
Just masked it off and sprayed with a couple of light coats. Still reflects but not the bright yellow eyesore it was.
Just masked it off and sprayed with a couple of light coats. Still reflects but not the bright yellow eyesore it was.
0 2019/07/24 03:42:25
About $12 from Autozone
About $12 from Autozone
0 2019/07/24 03:41:05
Around $12 at Autozone.
Around $12 at Autozone.
0 2019/07/24 03:37:19
The beach sand that was all over the deck and approach ramps made turning my ride around to get out very challanging. If you look closely, you can see the glasses on the seat.
The beach sand that was all over the deck and approach ramps made turning my ride around to get out very challanging. If you look closely, you can see the glasses on the seat.
0 2019/07/21 08:50:44
I had a lot of choices where to mount the GPS antenna. Under the seat or inside the fairing was the obvious locations. However, I chose to mount it outside on top of the fairing like I did with the XM Antenna to make sure it could see the satelite. I can easily move it later if I want.
I had a lot of choices where to mount the GPS antenna. Under the seat or inside the fairing was the obvious locations. However, I chose to mount it outside on top of the fairing like I did with the XM Antenna to make sure it could see the satelite. I can easily move it later if I want.
0 2019/07/17 07:27:24
Yellow wire spliced into a red/yellow wire, that is a switched power source, just behind the unused P&A connector.
Yellow wire spliced into a red/yellow wire, that is a switched power source, just behind the unused P&A connector.
0 2019/07/17 07:21:23
Under seat Red wire from power module connected to unused red/blue fused wire in Accessary 2 harness. Black rund to ground. Had some difficulty finding a path to get the Yellow down to under the left cover to a switched power source.
Under seat Red wire from power module connected to unused red/blue fused wire in Accessary 2 harness. Black rund to ground. Had some difficulty finding a path to get the Yellow down to under the left cover to a switched power source.
0 2019/07/17 07:21:19
Easy access to DVR to remove SD Card when HB's turned to fra left. If you look closely you can just see a little bit of the power module attached to the bikle frame with automotive high strength double stick tape tucked behind the main wiring harness.
Easy access to DVR to remove SD Card when HB's turned to fra left. If you look closely you can just see a little bit of the power module attached to the bikle frame with automotive high strength double stick tape tucked behind the main wiring harness.
0 2019/07/17 07:16:44
Plenty of clearance.
Plenty of clearance.
0 2019/07/17 07:16:40
DVR mounted on outside face of switch console with automotive high strength double stick tape.
DVR mounted on outside face of switch console with automotive high strength double stick tape.
0 2019/07/17 07:16:36
Side View of front Camera. Hope it is far enough forward so image is not washed out by headlight.
Side View of front Camera. Hope it is far enough forward so image is not washed out by headlight.
0 2019/07/17 07:10:26
Fron view of front camera, not very noticable. Lots of room so will not contact fender. Good centered unobstucted view to front.
Fron view of front camera, not very noticable. Lots of room so will not contact fender. Good centered unobstucted view to front.
0 2019/07/17 07:10:23
Rear Camera. Nicely centered with unobstructed view to rear. Again, hopefully image will not be washed out by my rear Run/Signal/Brake LED lighting.
Rear Camera. Nicely centered with unobstructed view to rear. Again, hopefully image will not be washed out by my rear Run/Signal/Brake LED lighting.
0 2019/07/17 07:10:18
I had a lot of choices where to mount the GPS antenna. Under the seat or inside the fairing were some of the obious locations. I decided to mount it outside on top of the fairing, similar to how I mounted the XM antenna, to insure it woud be able to get a good signal from the satelite. Easily moved if I want later.
I had a lot of choices where to mount the GPS antenna. Under the seat or inside the fairing were some of the obious locations. I decided to mount it outside on top of the fairing, similar to how I mounted the XM antenna, to insure it woud be able to get a good signal from the satelite. Easily moved if I want later.
0 2019/07/17 06:47:50
0 2019/07/17 06:47:02
The Yellow wire was spliced to the Red/Yellow wire, switched power, behind the P&A connector under the left side panel.
The Yellow wire was spliced to the Red/Yellow wire, switched power, behind the P&A connector under the left side panel.
0 2019/07/17 06:37:15
Under seat, the Red wire from power module was connected to the red/blue wire which is an unused fused Accessory 2 power - on all the time. Black run to ground. It was difficult to find a clear route for the Yellow down to a Switched Power source, but finally managed to find a path.
Under seat, the Red wire from power module was connected to the red/blue wire which is an unused fused Accessory 2 power - on all the time. Black run to ground. It was difficult to find a clear route for the Yellow down to a Switched Power source, but finally managed to find a path.
0 2019/07/17 06:37:11
Rear camera with a clear view of what is behind. Again, hopefully wont get washout by rear tail/ru/brake LED's.
Rear camera with a clear view of what is behind. Again, hopefully wont get washout by rear tail/ru/brake LED's.
0 2019/07/17 06:34:04
Easily accessed when HB's are turned full left. If you look close you can see the power module affixed to the frame with the automotive high strength double stick tape tucked in behind the large main harness.
Easily accessed when HB's are turned full left. If you look close you can see the power module affixed to the frame with the automotive high strength double stick tape tucked in behind the large main harness.
0 2019/07/17 06:27:50
Clears console with out a problem.
Clears console with out a problem.
0 2019/07/17 06:27:46
DVR mounted with automotive high strength double stick tape to face of switch housing.
DVR mounted with automotive high strength double stick tape to face of switch housing.
0 2019/07/17 06:27:43
Side view of Front Camera. Hopefully forward enough that it wont get washed out from headlight.
Side view of Front Camera. Hopefully forward enough that it wont get washed out from headlight.
0 2019/07/17 06:24:54
Front view of front camera. Not very conspicuous.
Front view of front camera. Not very conspicuous.
0 2019/07/17 06:24:50
Side view of Front camera.
Side view of Front camera.
0 2019/07/17 06:13:12
Front view of front camera
Front view of front camera
0 2019/07/17 06:13:04
0 2019/07/17 02:59:43
0 2019/07/17 02:58:00
Horizontal adjustment can not be accomplished
Horizontal adjustment can not be accomplished
0 2019/07/15 08:54:05
Now mounted with L bracket
Now mounted with L bracket
0 2019/07/15 08:54:01
No horizontal adjustment
No horizontal adjustment
0 2019/07/15 08:50:29
Good location
Good location
0 2019/07/15 08:50:26
0 2019/07/15 08:48:47
0 2019/07/15 08:48:44
Ued hammer and block of wood to bend bracket.
Ued hammer and block of wood to bend bracket.
0 2019/07/15 08:46:12
Reflector removed
Reflector removed
0 2019/07/15 08:45:24
The saved reflector bracket
The saved reflector bracket
0 2019/07/15 08:43:10
0 2019/07/15 08:43:06
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
© 2026 MH Sub I, LLC dba Internet Brands