Battery Disconnects and Re-Configuring Alarm
Thread Starter
|
Banned
Joined: May 2005
Posts: 14,496
Likes: 156
From:
Battery Disconnects and Re-Configuring Alarm
After reconnecting the battery, the security system will not enter the configuration mode on the first attempt. Therefore, after all battery reconnects, the configuration sequence must be modified as follows...
1. Set run switch to OFF, cycle ignition key ON-OFF-ON-OFF-ON and press left turn signal switch TWICE.
Wait for one to three confirmation flashes of the turn signals and then set ignition switch to OFF.
2. Repeat steps listed above.
3. Continue with configuration sequence listed below.
1. Set run switch to OFF, cycle ignition key ON-OFF-ON-OFF-ON and press left turn signal switch TWICE.
Wait for one to three confirmation flashes of the turn signals and then set ignition switch to OFF.
2. Repeat steps listed above.
3. Continue with configuration sequence listed below.
Thread
Thread Starter
Forum
Replies
Last Post
huntrowmar
General Harley Davidson Chat
42
Aug 27, 2013 04:38 PM
2006, alarm, battary, battery, configuration, davidson, desconect, disconnect, disconnecting, dyna, glide, harley, security, system, ultra
