Which Cams ?
#1
Which Cams ?
I have a 2012 103 Street Glide pushing 45,000 miles. The lifters are starting to make some noise until the motor warms up . I'm thinking if I'm going to replace them I may as well go ahead and install some gear driven cams as well . Any suggestions which ones to get . The only mods to the bike is a Vance & Hines full exhaust with the cross over and the big slip ons , with a Big sucker air intake. I would like to increase the throttle response some , but don't want to decrease the fuel mileage or dependability as I primarily use this bike for touring. I have other bikes for the go fast stuff.
Thanks
Thanks
#3
S&S lifters/pushrods.
Andrews 48's or a Wood 222.
If you brought the engine to 10.2 cr, then an Andrews 57, Wood 6-6, would be good choices as well, then.
Scott
Andrews 48's or a Wood 222.
If you brought the engine to 10.2 cr, then an Andrews 57, Wood 6-6, would be good choices as well, then.
Scott
__________________
HILLSIDE MOTORCYCLE & MACHINE, INC.
HARLEY-DAVIDSON SPEED & SERVICE CENTER
5225 SOUTH MAIN ST., MUNNSVILLE, N.Y. 13409
Sales/Support 315-495-6650
www.hillsidecycle.com
Walk-in Retail Showroom
Complete H-D Machine Shop
Case & cylinder boring
Complete Cylinder Head Shop
High-Performance Engine Kits
Crank Rebuilding
Direct Link & PowerVision Tuning
Goodson HD Tooling Manufacturer
Maxton Mile World Record
4500 sq ft. facility
OVER 35 YEARS OF H-D ENGINE BUILDING.
See us on Facebook.
HILLSIDE MOTORCYCLE & MACHINE, INC.
HARLEY-DAVIDSON SPEED & SERVICE CENTER
5225 SOUTH MAIN ST., MUNNSVILLE, N.Y. 13409
Sales/Support 315-495-6650
www.hillsidecycle.com
Walk-in Retail Showroom
Complete H-D Machine Shop
Case & cylinder boring
Complete Cylinder Head Shop
High-Performance Engine Kits
Crank Rebuilding
Direct Link & PowerVision Tuning
Goodson HD Tooling Manufacturer
Maxton Mile World Record
4500 sq ft. facility
OVER 35 YEARS OF H-D ENGINE BUILDING.
See us on Facebook.
Thread
Thread Starter
Forum
Replies
Last Post