CV Carb Broken Fuel Inlet Replacement
Thread Starter
|
Banned
Joined: May 2005
Posts: 14,496
Likes: 156
From:
CV Carb Broken Fuel Inlet Replacement
H-D has used Keihin butterfly and CV type carburetors since 1976. The same injection molded fuel inlet elbow is installed on both types. The OEM plastic elbow breaks easily, can be affected by today's fuels and has a restrictive flow rate. Creative Cycle Products fuel inlet elbow is made from brass and flows 40% more fuel. . The elbow is designed to be a direct replacement for the OEM item.
To remove the broken end that is lodged in the carb, try threading a self tapping screw or a proper sized bolt into the broken piece and pulling it out with this.
Available here http://www.creativecycles.com/
You may have to contact them by phone for the listing.
[IMG]local://upfiles/2318/375737CB8D4A4D33BD9733A847930098.gif[/IMG]
To remove the broken end that is lodged in the carb, try threading a self tapping screw or a proper sized bolt into the broken piece and pulling it out with this.
Available here http://www.creativecycles.com/
You may have to contact them by phone for the listing.
[IMG]local://upfiles/2318/375737CB8D4A4D33BD9733A847930098.gif[/IMG]
Thread
Thread Starter
Forum
Replies
Last Post
