JRK, MSD Ignition part # 8963

three wires -

power

ground

third is a GMR pickup.
Clips over the Ion Sensing Wire on the coil. No cutting.

Easy add on, works great.

mud

.

 

Great mod, but who would actually pay any attention to it? I mean, I have a shift light on my Saturn but I have no use for it. But on a HD I see it as an extra add on that's there just so I can say I have one.

 

i like that one

 

thanks mud! just added that to my list! thanks bud! i am going to add one to the bobber build as well!

 

This definitely falls under the "Under $50" category.

Cost, $3 for a jello shooter (the alcoholic type) and maybe $2 for some 1/4" clear tubing approx 12" long.

Needing to bleed my front brakes because I did a cable swap, I came up with this idea. I had the 'jello' syringe in my drawer that I kept from the beach last year. Actually kept a few of them. They're pretty big, as it's labeled "2oz" on the side.

It did take a few sessions to clear the old fluid/air out of the lines before I saw new brake fluid but those brakes never felt better. This took 15min by myself. I'm sure you could cut that time down with the help of a friend topping off the master cylinder as needed.

I'm sure you can figure out how this works:

 

Great idea!!!!

 

I am posting this on the under $50.00 thread because someone will have figured out how to make/adjust a bracket that will show the Speedo in the stock position rather than facing down

Accutronic has one but I do not think I could mount my windshield with it in place need to mount is stock position on bars

TIA

 

check out the one the guys use in the sporty section when they move the nightster speedo's down to the side of the bike! looks and works great!!!!

 

How does it work??

mud

 

Modify the windshield.

Easier than modifying the bracket.

mud