New Amp

Reply Subscribe

Thread Tools

Search this Thread

Feb 11, 2019 | 09:41 AM

InthewindMN

Thread Starter

Outstanding HDF Member

Joined: Jan 2014

Posts: 2,482

Likes: 239

From: Minnesota

New Amp Released

nvx just released a new amp. The sonic dyno test looks impressive for the size at 300x2. Anyone try it yet?
https://www.sonicelectronix.com/item...NVX-VADM4.html

Last edited by InthewindMN; Feb 11, 2019 at 10:50 AM.

Feb 11, 2019 | 10:51 AM

Babyboy

Stellar HDF Member

Joined: Aug 2014

Posts: 2,838

Likes: 572

From: Lockport Illinois

That amp wiring set up looks like the Cerwin Vega or the Diamond Audio V2 series amps but at a lower cost

Feb 11, 2019 | 10:53 AM

InthewindMN

Thread Starter

Outstanding HDF Member

Joined: Jan 2014

Posts: 2,482

Likes: 239

From: Minnesota

Size is close to a gz micro, I wonder if it will fit in the cb hole?

Feb 11, 2019 | 11:56 AM

Dsm Limited

Club Member

Joined: Sep 2014

Posts: 7,618

Likes: 10,437

From: Des moines IA

That link is to a 400w amp. 75x4 4ch@4ohm
. 200wx2@2ohm

Feb 11, 2019 | 12:37 PM

InthewindMN

Thread Starter

Outstanding HDF Member

Joined: Jan 2014

Posts: 2,482

Likes: 239

From: Minnesota

Quote:

Originally Posted by Dsm Limited

That link is to a 400w amp. 75x4 4ch@4ohm
. 200wx2@2ohm

watch the video under the description. It dynos higher than spec
dyno results
116x4@ 4ohm
170x4 @ 2ohm
310x2 4ohm bridge

Last edited by InthewindMN; Feb 11, 2019 at 12:46 PM.

Feb 11, 2019 | 12:50 PM

marshallb

Road Warrior

Joined: Jun 2017

Posts: 1,832

Likes: 174

From: Indiana

I wish sonic electronix dynoed amps a little more controlled. They should load all 4 channels for testing, either with load resistors or run it 8 ohms bridged in two channels to simulate 4ohm 4 channels. I saw another dyno where the resting voltage was over 15V which isn't quite fair either.