Hi:

Installing the Screaming Eagle stage 1 air intake on an 08 Dyna. Everything is simple except where do I mount the little clip that holds the wiring harness? I don't have a shop manual yet (yea, I'm getting one) and all the instructions say is to, "install it in the six o-clock position". I know this has been done thousands of times, so hopefully somebody knows where it goes. Thanks!!

 

I used a tiny zip tie and tied it to my Idle air control valve. Threw clip in trash.

 

Yup ^^^^

 

Could you please tell us about your garage floor. What is it? Very nice!

 

Funny because I didn't know that was a garage...
I thought the dude just put his bike in an empty room in the house and took a picture. Looks like a painted floor.

And to the OPs question, I did the same. Hid the wire with a zip tie and went about my day.

 

I think this is an acid treatment used in decorative concrete. This is on a slick finish with probably two colors. You see this stuff all the time in commercial applications.