SERT MAP INFO???
Thread Starter
|
Cruiser
Joined: Oct 2006
Posts: 212
Likes: 0
From: North Ga.
SERT MAP INFO???
I was hoping someone could help me out with a map. I just received my SERT and would like to re map my bike. I have a 05 Dyna Super Glide Custom fuel injected. I've done a little work to it hear we go.
SE high flow air cleaner
SE Tunabletwo-into-one exhaust systempart # 80091-03
MSD Coil
MSD 8.5 Spark plug wires
I ported and polished the intake manifold (removed all casting marks inside manifold)
I reworked a stock set of heads that had 100 miles on them
Ported and polished the intake and exhaust ports also cleaned up the combustion chamber. To make sure both heads were the same I used my Cylinder Head CC'ing kit that I used when I drag raced years ago. I more less cleaned everything up on the heads and made sure both cylinder heads were identical.
The bike runs great, better than when I started.I know with a new MAP I would really feel more as to take advantage of all the work I've done.I'm prettygood at turning wrenches and machine work I've built many nitrous and blower motors from my Drag Racing days, but computers systems I suck at. Any ideas on a MAP I should start off with would be great. I know with some new mapping this thing should scream.Any suggestions would be greatly appreciated.
Thanks, Scratch
SE high flow air cleaner
SE Tunabletwo-into-one exhaust systempart # 80091-03
MSD Coil
MSD 8.5 Spark plug wires
I ported and polished the intake manifold (removed all casting marks inside manifold)
I reworked a stock set of heads that had 100 miles on them
Ported and polished the intake and exhaust ports also cleaned up the combustion chamber. To make sure both heads were the same I used my Cylinder Head CC'ing kit that I used when I drag raced years ago. I more less cleaned everything up on the heads and made sure both cylinder heads were identical.
The bike runs great, better than when I started.I know with a new MAP I would really feel more as to take advantage of all the work I've done.I'm prettygood at turning wrenches and machine work I've built many nitrous and blower motors from my Drag Racing days, but computers systems I suck at. Any ideas on a MAP I should start off with would be great. I know with some new mapping this thing should scream.Any suggestions would be greatly appreciated.
Thanks, Scratch
Thread
Thread Starter
Forum
Replies
Last Post
Mr. Scratch
Ignition/Tuner/ECM/Fuel Injection
0
Sep 28, 2007 11:23 PM
