Hey guys, pretty sure Ive fallen victim to the 06 stator issues. Just making sure Im checking it right, the plug that comes from the primary should have 16-20 vac at idle on two of the pins?

 

To be more specific, the plug that goes from the primary to the voltage regulator

 

Also does anyone have the part# for the 07 Rotor?

 

Did yours grenade completely? If not you can have the 8 bolt heads tack welded and take care of your problem. I used to have a photo of mine but I can't find it sorry.

the rotor is PN 40356-07
the stator is PN 30017-07 about $300.00 for both

 

will it cause balance issues for the rotor?

 

https://www.hdforums.com/forum/dyna-...ame-apart.html

 

Just pulled my primary, nice little chunks of copper. Dont have a primary locking tool could someone shoot me the dimensions, I have some UHMW that I think I can shape into one.

 

Zanotti HD has the complete rotor /stator kit, part number 40356-06B. (includes the 4 new bolts for the stator) for $200.20 + shipping. I just replaced the rotor and stator in my 06 WideGlide. It is the 07 welded rotor, if the rotor and stator are ordered separately it may cost you more. The locking bar from George's Garage is 7.125 inches long X 3/8 inch thick X 15/16 inch wide. The ends are rounded so they will fit into the sprocket teeth.

 

That should be a recall. just not right........

 

Yes it should be a recall, but I would have settled for a warning