Does anyone who has intalled the Baker IPB in a 2006 Dyna TC (without the alignment dowels) have an update for us? Does anyone have 10k to 15k on the bearing yet? Have you inspected the bearing for wear and/or the primary fluid for shavings etc. Honestly, I'd sure like the Baker bearing to be the cure for the IPB issue, but nobody who's installed one has reported back to the forum yet. Any updates would be greatly appreciated.

 

i have 8500 on mine working great, when we pulled apart my primary for the moto work i only had about 5g on it but it looed great

 

I did mine on a 06 WG about the same time as JRK and it has about 10k on it. No metal in the oil and sounds fine. I would think that if it was going bad it would take out the oil seal by the bearing.

 

That's good to know.

I have only 5,000miles on mine and no noise.

Anyone else???

 

Only 3k on mine after Baker and ok. Great thread. Would like to hear back at end of season for update

 

What is the part nr. for the baker ipb? The only one I can find is #189-56 & Bakers says it wont fit the '06 dyna??

 

http://store.bakerdrivetrain.com/Pro...e=4&eq=&key=it

This is the one. Your number is correct and does fit the 06

 

Thanks for that.. There seems to be some confusion over at Drag Specialties, they exclude the '06 Dyna in their catalog while Baker does not.

 

This is good info, as I am going to have to do something about my IPB soon.