5000 hard miles, 107 still going strong
#1
#2
#3
I did the 107 kit on my 2010 ultra and same problem, at 3 grand the clutch starts to slip. Fuel Moto sold me a VP clutch that was a 5 minute bolt on. I have 7% easier clutch pull at idle than stock and the instructions say it will hold my HP and Torque no problem. 116hp and 121 tq. They were right. They are not as cheap as a spring but it was a good investment for me. I have hand/ grip issues and the light clutch pull is needed. Give them a call about one.
#4
I did the 107 kit on my 2010 ultra and same problem, at 3 grand the clutch starts to slip. Fuel Moto sold me a VP clutch that was a 5 minute bolt on. I have 7% easier clutch pull at idle than stock and the instructions say it will hold my HP and Torque no problem. 116hp and 121 tq. They were right. They are not as cheap as a spring but it was a good investment for me. I have hand/ grip issues and the light clutch pull is needed. Give them a call about one.
Went back stock spring and AIM VPC and Barnett clutch plates no slippin now. Just pure fun.
Thread
Thread Starter
Forum
Replies
Last Post