Welding
Thread Starter
|
Advanced
Joined: Aug 2008
Posts: 82
Likes: 0
Welding
Need to have my frame welded. Rather than strip the whole bike down I can remove the bags and rear fender to do it. Question is do I need to disconnect the battery and or remove fuses for any reason
Outstanding HDF Member
Joined: Apr 2013
Posts: 3,369
Likes: 472
From: CC TX
One assumption: Mig with gas.
Road Master
Joined: Aug 2012
Posts: 1,008
Likes: 229
From: Saskatchewan
I would disconnect the battery as well as unplugging the ECM. I have seen sensitive electronics ruined as well as crank bearings fused to cranks on heavy equipment making for costly repairs. Keeping the welder's ground as close to the work as possible will pretty much eliminate any issues but why take a chance when these precautions are quick and simple to do.
Trending Topics
Grand HDF Member
Joined: Nov 2012
Posts: 3,784
Likes: 100
From: Pasadena TX
HD Forum Stories
The Best of Harley-Davidson for Lifelong Riders
8 Best Harley-Davidson Motorcycles Ever
Pouria Savadkouei
10 Worst Harley-Davidson Motorcycles Ever
Pouria Savadkouei
Killer Custom's Jail Break Is The Breakout That Refused to Blend In
Verdad Gallardo
Crazy Bunderbike Build Looks Amazing, But Is It Impossible to Ride?
Verdad Gallardo
Harley-Davidson Reveals Super Cool Cafe Racer Concept
Verdad Gallardo
Engraved Rebellion: Inside Bundnerbike's Glam Rock II
Verdad Gallardo
10 Motorcycles You Should Never Buy
Joe Kucinski
10 Things Harley-Davidson Needs to Fix in 2026
Verdad Gallardo
Southpaw Super Glide: A Left-Hand-Drive 1979 Harley FXE Built to Fit the Rider
Verdad Gallardo
Seasoned HDF Member
Joined: Jan 2011
Posts: 157,326
Likes: 56,888
From: Michigan 15 Minutes East Of Hell
Several good suggestions above ... Remove/unhook the battery. Good clean ground close to your welding point. Cover everything with a heavy material near/around the area to avoid damage. Use a well ventilated area ( consider the sparks and fuel ).