Starts and immediately shuts off
#1
Starts and immediately shuts off
I recently purchased a 2010 SG. When I bought the bike, the speedo and tach did not work. I figured out the gauges were not getting power from the battery. After fixing the issue, the bike now starts and immediately dies. The red security key stays on, and check engine light kicks on as soon as it dies. I checked in diagnostics and found the P1010 code. I’ve done the computer relearn with the password and the bike will not stay running. When I try clearing the P1010 code, I get a PN of ctb00901. Does anyone know what part this is? I can’t seem to find it.
Last edited by Shaunc5; 08-23-2020 at 06:15 PM.
#3
Are you by chance using an FP3 ? If so , this issue is known to happen when it's connected . To remedy the problem , you can either remove the unit once the tune is complete or turn the switch to run before turning the ignition on , worked for me . For some reason the security doesn't complete it's communication . Maybe this issue is known to happen to other tuners as well , I don't know .
My bike would start right away and then stall , it would start on the second attempt and stay running . I would just clear the code , it would only happen once every ten or so starts .
My bike would start right away and then stall , it would start on the second attempt and stay running . I would just clear the code , it would only happen once every ten or so starts .
#4
#5
Hoping this information may help , step 4 tells me if the tssm can't be reset you might have an error / issue going on . Sounds crazy but even a blown bulb could cause an issue as well .
I'm no electrical expert here , just found this interesting and thought it might help .
https://www.hdforums.com/how-tos/a/h...le-tssm-414025
I'm no electrical expert here , just found this interesting and thought it might help .
https://www.hdforums.com/how-tos/a/h...le-tssm-414025
Thread
Thread Starter
Forum
Replies
Last Post
vbx07
Ignition/Tuner/ECM/Fuel Injection
2
09-17-2011 08:01 AM