brett
Thread Starter
|
Stage I
Joined: Apr 2012
Posts: 1
Likes: 0
From: melbourne australia
brett
hi all, I have just purchased a 2012 fat bob and have had a vance and hines big radius 2 into 1 fitted. on my first ride, I noticed the bolt that holds the passenger foot peg on the right side had dented the top of the heat shield. Harley fitted the exhaust but say they followed all instructions from v and h. Anyone else had a similar problem?
Seasoned HDF Member
Joined: Aug 2007
Posts: 21,751
Likes: 17,620
From: Driftless Area
After extensive testing in Research & Development, the designers at the H-D factory have determined that locating that particular bolt any differently would not enable your passenger to melt her shoe all over that section of the exhaust.
Thank you for your inquiry.
Thank you for your inquiry.
Thread
Thread Starter
Forum
Replies
Last Post
