angled valve stem?
#1
Join Date: May 2012
Location: Port St Lucie Florida
Posts: 11,396
Received 3,389 Likes
on
1,560 Posts
angled valve stem?
I'm getting a new rear tire next week on my 12 Heritage Classic. I find it really difficult to get my arthritic fingers around the spokes to screw on the compressor connector when I check and add air.
Do HD make an angled valve stem for the interlaced spoke wheel/tire (Dunlop white walls) which would make my life easier? I checked online but was not able to find a part #.
Do HD make an angled valve stem for the interlaced spoke wheel/tire (Dunlop white walls) which would make my life easier? I checked online but was not able to find a part #.
#2
I'm getting a new rear tire next week on my 12 Heritage Classic. I find it really difficult to get my arthritic fingers around the spokes to screw on the compressor connector when I check and add air.
Do HD make an angled valve stem for the interlaced spoke wheel/tire (Dunlop white walls) which would make my life easier? I checked online but was not able to find a part #.
Do HD make an angled valve stem for the interlaced spoke wheel/tire (Dunlop white walls) which would make my life easier? I checked online but was not able to find a part #.
#3
Your Heritage running tubeless wheels?
Just asking cause my 2003 Heritage has tubes.
If you are running a tubeless wheel, I've heard good things about these;
http://www.motorcycleanchor.com/tire_valves/index.htm
I plan on putting them on my Limited the next time the tires are off...
Just asking cause my 2003 Heritage has tubes.
If you are running a tubeless wheel, I've heard good things about these;
http://www.motorcycleanchor.com/tire_valves/index.htm
I plan on putting them on my Limited the next time the tires are off...
Thread
Thread Starter
Forum
Replies
Last Post