replace axle???
Thread Starter
|
Advanced
Joined: Jul 2006
Posts: 95
Likes: 0
From: MA/NH Border
replace axle???
I got a 19" six spoke front rim for my 04 sporty. It's for a 2005 dyna, which has the 1" bearings. My question is, do I need to replace the bearings to 3/4", or can I simply swap out the axle for a 1"? Thanks.
Ultimate HDF Member
Joined: Jun 2006
Posts: 8,438
Likes: 6
From: Gulf Coast of Mississippi
RE: replace axle???
Would a one inch axle fit your fork?
But I would think bearing would be the way to go...
I was going to go with a different rear wheel on my 05', it called for 3/4 bearings...and the Indy guy told me we'd just put one inch bearings for my one inch axle...
Charlie D.
But I would think bearing would be the way to go...
I was going to go with a different rear wheel on my 05', it called for 3/4 bearings...and the Indy guy told me we'd just put one inch bearings for my one inch axle...
Charlie D.
Thread Starter
|
Advanced
Joined: Jul 2006
Posts: 95
Likes: 0
From: MA/NH Border
RE: replace axle???
I went to Harleys' web site, http://www.harley-davidson.com/gma/g...bmLocale=en_US....................
They say the fork sliders fit 2000 and up models, so I'm assuming the 2 different axles are the same at the ends, and just turned down more where it goes through the bearings. But I could be very wrong here.
They say the fork sliders fit 2000 and up models, so I'm assuming the 2 different axles are the same at the ends, and just turned down more where it goes through the bearings. But I could be very wrong here.
Thread
Thread Starter
Forum
Replies
Last Post
