TTS: Need help. TTS on a 2015 road glide. Newbie to this stuff.
#11
04-04-2018, 07:30 AM
Steve I super appreciate your time and help. My next question. After each fr run I save it. Fr1 fr2 fr3 fr4 and so on. I creat a new calibration and add it to my bike after each tune. When generating my new tune do I add all the runs to the new calibration or just my most recent. Example my first calibration I’ll add just fr1. But on my second calibration do I add fr1 and fr2 or just fr2? Thank you.
#12
04-10-2018, 10:56 AM
HD EFI Guru
You first place a tune into the bike, Let's call/name that Tune 1. Then you collect the VTune data by riding the bike this could be one or several recordings. Let's name those 1st-FR1, -FR2 ect. You take Tune 1 and data from 1st-FRxx and allow Vtune3 to make you a new tune. Name the new calibration Tune 2. Install Tune 2 in the bike. You never use anything from Tune 1 or 1st-FRxx again. Each time you put a new tune into the bike you should only use data collected from that tune. I like to place a number in the name to each set, that way I do not mix them up by mistake.
Thread
Thread Starter
Forum
Replies
Last Post
Callie Bud
Ignition/Tuner/ECM/Fuel Injection
7
07-13-2018 11:18 PM
edmroadglide
Ignition/Tuner/ECM/Fuel Injection
2
05-23-2018 05:05 PM