introduction
Thread Starter
|
3rd Gear
Joined: Nov 2005
Posts: 7
Likes: 0
introduction
Hello All,
I am a recent transplant from Asheville, NC to Maple Grove, MN. I am a sales trainer here for a major medical device manufacturer. I am currently about 80% done with my current build. It is my 4th build and definately my most exotic. I am stuffing a 127" polished engine in a stock dimension softail. I also am running a 48 IDF down draft Weber carburetor. I haven't fired this thing up yet and am a little scared of getting this exotic setup running! It also has a front end from a '59 Panhead that I have had completely restored including re polishing the aluminum nacelle. I could go on and on but will send picks when I am doing a hole shot!
Todd Ihnken
I am a recent transplant from Asheville, NC to Maple Grove, MN. I am a sales trainer here for a major medical device manufacturer. I am currently about 80% done with my current build. It is my 4th build and definately my most exotic. I am stuffing a 127" polished engine in a stock dimension softail. I also am running a 48 IDF down draft Weber carburetor. I haven't fired this thing up yet and am a little scared of getting this exotic setup running! It also has a front end from a '59 Panhead that I have had completely restored including re polishing the aluminum nacelle. I could go on and on but will send picks when I am doing a hole shot!
Todd Ihnken
Ultimate HDF Member
Joined: May 2005
Posts: 5,187
Likes: 1
From: Rhode Island
RE: introduction
Welcome from Rhode Island.
Downeast Maine.[sm=welcomesign.gif]