Adjusting pushrods
#1
Adjusting pushrods
Ok guys, lost my notes and tried searching this and ended up with out an answer. I am going to adjust pushrods on my bike (v-thunder) put them in 2 years ago after doing a cam swap. I know lifters need to be on low spot of cam at tdc. But I can't remember the procedure for lifter bleed down since the bike has been ran, and I am not pulling the lifters.
Do I need to bleed them to adjust and if so how do you do that again? Help is greatly appreciated!
Do I need to bleed them to adjust and if so how do you do that again? Help is greatly appreciated!
#2
Join Date: Dec 2010
Location: Coromandel Peninsula New Zealand
Posts: 6,986
Received 447 Likes
on
255 Posts
http://www.vthunder.com/(S(dknlqxf2s...les/VT-323.pdf
Instructions assume that lifters have been run. If they haven't you would need to run the motor for a few mins and the readjust with the motor cold. But yours have been run so just follow the sheet.
Instructions assume that lifters have been run. If they haven't you would need to run the motor for a few mins and the readjust with the motor cold. But yours have been run so just follow the sheet.
Thread
Thread Starter
Forum
Replies
Last Post
danzio
General Harley Davidson Chat
1
05-28-2016 01:26 PM