I loaded Basic Map to PCIII how do I do andvance
Road Captain
Joined: Nov 2006
Posts: 709
Likes: 1
From:
RE: I loaded Basic Map to PCIII how do I do andvance
Start with a canned map from dynojet similar to the set-up of the bike. If the bike is running rich or lean pull up the compare maps feature of the software and compare the canned maps available to see which maybe a better fit. Once you get close you can alter the AFR numbers for your bike. Best way to do it would be with a Dyno and/or O2 sensor. But you could get close with seat of the pants dyno. BTW if you do the math it is about the same amount of dollars between your own wideband O2 sensor set-up and a single Dyno Run.
Road Captain
Joined: Nov 2006
Posts: 709
Likes: 1
From:
RE: I loaded Basic Map to PCIII how do I do andvance
Load a base map similar to your build and then plug in your twin scan and WEGo and go for a ride and record the O2 Data. I believe the WEGo will create a percentage change table you would then apply to your PCIII MAP. It is in their Manual. Record different areas of your riding like free cruising and stop and go traffic and see what kind of data you get back.
Thread
Thread Starter
Forum
Replies
Last Post
