.
mudindex
.
.
post# 1033 …… rear running lights ....... Posted by Citoriplus
.
post# 1045 …… J&S jack improvements.....Posted by mud
.
post# 1046 …… 12 Volt plug on the bike.......Posted by dklozik
.
post# 1053 …… fork stem nut clock....... Posted by chengdave2003
.
post# 1057 …… stripping and polishing primary, cam and clutch cover....... Posted by mud
.........1057 is missing some pix
.
post# 1062 …… polishing aluminium pieces....... Posted by RudeDog
.
post# 1065 ……tank lift......Posted by mud
.........1065 is missing some pix
.
post# 1069 …… quick release fuel valve....... Posted by lee
.
post# 1075 …… rocker box wrinkle black out....... Posted by boutellepc
.
post# 1081 …… video camera mount.......Posted by mud
.
post# 1085 …… high beam garage door opener....... Posted by Streets of Fire
.
post# 1089 …… video upload to YouTube.......Posted by vetto
.
post# 1091…… molex connector poking tool....... Posted by mud
.
post# 1092 …… AMP fitting release tool......Posted by mud
.
post# 1093 …… Deutsch fitting crimper......Posted by mud
.
post# 1094 …… wiring tail light.....Posted by mud
.
post# 1096 …… old school tunable baffles......Posted by vetto
.
post# 1097 …… rocker c seat modification....... Posted by robo01
.

CLICK BELOW for INDEXES

.

 

Here is a tool for initial wheel alignment in the rear fork.

I used a six inch piece of 1/8 inch stainless round stock,
and a snug fitting o-Ring.

Grind one end to a blunt point then mark at 1 1/4" back.

Place the stock in a vise at the mark,
then bend it over and hammer down for a nice sharp 90.
.
.
measuring at the rear axle

a tool I made in 2007..........
.

.
.
a tool I made in 2010..........
.

.

.

.

.

.

.
my red mark below is the witness line.
.

.
.

 

Yeah Buddy, I got one just like that in my box.

 

I figure you would have this one Brian.

What else you got??

Make your own tools is a great pastime.

mud

 

Trim to fit license plate
Remove plate, put aluminum tape over license plate mount, press down on tape to locate edges and thru holes, use a xacto blade to cut along inside edge of license plate mount, cut out thru holes, pull off tape and put on a cereal box, use scissors to cut out around the outer edge of the tape, cut out thru holes, align template to your license plate using thru holes, tape in place, use a die grinder with a file type bit and cut close to the edge, then put a piece of sand paper on your garage floor to use as a flat plate, sand the edges of your plate smooth and straight.

Before



After

 

WS6 Formula...the King of the Details

(but I did like the chrome shocks better)

 

Thanks Formula. Nice job.

I've copied a few of yours through the years,
and I know you got a million of em.

My license plate, I trimmed off about 1/4" all the way around
to make it smaller for the mudSickle application.

mud

 

Thanks for the index, Mud!

(bookmarked.)

 

MUD the index is awesome!!! looks great!

 

Yessir Mr.Kid. My pleasure.

Post up some pix if you have an opportunity.

Mud