Target Voltage
Thread Starter
|
Stellar HDF Member
Joined: Oct 2015
Posts: 2,681
Likes: 851
From: Puyallup, wa
Target Voltage
I will be installing My new system this week. 2018 RGU I will be getting the RF flash. SD 1200.4 2 ohm, fairing GZ 6.5 coaxial, rears Mmats 690.cx. I will run this bridged parallel. What would be a good starting output voltage? Thanks.
Ultimate HDF Member
Joined: Mar 2015
Posts: 6,446
Likes: 873
From: TEXAS
Wire the GZs parallel & bridged w puts u at 2 ohms thus set about 32 vac on those by using the appropriate bridged terminals on amp.
I wouldn't bridge the Mmats initially. Run them straight up in stereo and set those at about 25 vac.
T
I wouldn't bridge the Mmats initially. Run them straight up in stereo and set those at about 25 vac.
T
Thread Starter
|
Stellar HDF Member
Joined: Oct 2015
Posts: 2,681
Likes: 851
From: Puyallup, wa
Thanks, I wasnt sure if the amp in stereo would get to 160W .
Thread Starter
|
Stellar HDF Member
Joined: Oct 2015
Posts: 2,681
Likes: 851
From: Puyallup, wa
Thanks, I am looking forward to hearing how this sounds.
Thread
Thread Starter
Forum
Replies
Last Post
1993FLHS
Ignition/Tuner/ECM/Fuel Injection
1
Apr 26, 2010 05:21 AM
